Dedicated circuits
Dedicated Circuit Installation in Duvall
When one appliance keeps taking out half the house, the appliance is usually not the problem.
Give the big loads their own supply
Older houses were wired for a household that did not own this much. A kitchen that now runs a microwave, a kettle and an air fryer off circuits intended for a toaster will keep tripping, and no amount of resetting changes that. A dedicated circuit runs from the panel to one piece of equipment and nothing else. It is the fix for appliances that trip under load, for shop tools that dim the lights when they start, and for well pumps and outbuildings that were never supposed to share with the house in the first place.
What the job includes
The right size, not the biggest
Conductor and breaker sized to the equipment's actual nameplate, which is the only figure that matters.
A route planned for the building
Through crawl space, attic or conduit, with underground runs where equipment sits in a shop or outbuilding.
Panel capacity checked first
If adding the circuit pushes the service past what it can carry, you find that out before we start, not after.
Permit, inspection and labelling
Filed where required, inspected, and the new breaker labelled so the next person knows what it feeds.
Typical reasons people call
The breaker goes when the appliance starts
Start-up current on motors and compressors is far higher than running current. A shared circuit often cannot take it.
Lights dim when equipment kicks in
Voltage drop under load, usually from too much on one run or a run that is too long for its size.
A new appliance arrived
Ranges, wall ovens, air handlers and workshop equipment are generally designed to sit on their own circuit.
There is a shop or barn on the property
Outbuildings fed off a house circuit are a common valley arrangement and a common source of trouble.
How the work runs
Read the nameplate
The equipment tells us what it needs. We start there rather than guessing from the model name.
Check the panel
Spare capacity and a free slot, or the options if there is neither.
Plan and run
Shortest practical route, correctly supported and protected.
Test and inspect
Under load, then signed off and labelled.
Questions about this work
How do I know if I need one?
If a specific appliance is what trips the breaker, almost certainly. If the trip happens at random with nothing obvious running, it may be a fault instead — which is a different job and worth diagnosing first.
Can you run power out to a shop or barn?
Yes. That is a feeder rather than a single circuit, usually underground, and it needs a disconnect at the far end. We quote it properly rather than stringing an extension cord across a yard.
Will my panel take another circuit?
Often yes. Where it will not, there are usually options short of a full panel change, and we will lay them out before you commit to anything.
Stop resetting the same breaker
Tell us what trips it and we will tell you whether a dedicated circuit is the answer.